Unroll the pattern and tape it to the wall where the letters will be installed. Check that the letters are level and centered in the area.

Do not level with the bottoms of the letters or the edge of the paper. Use the provided level lines only.

Stand-off mounting holes are marked near the center of the letters and logos. Drill pilot holes through the center of each mark for the appropriate fastener.

Power holes are marked in the middle of the letters and logos. Drill a 3/4 inch hole completely through the wall to the inside of the building.

Remove the pattern from the wall as soon as possible. Each letter has a sequence sticker on the back showing the order the letters or logos should be installed.

Fasten each cup to the wall using screws appropriate for the wall. Place the screw through the base of the cup and into the pilot hole created from the pattern.

Place the letters or logos on the wall, aligning the rods on the back of each letter with the mounted cups. Push the EZLit Power Link through the wall so it can be reached from inside the building.

Once the rods are seated in the cups, tighten the set screws with the supplied Allen wrench. We recommend running the rods all the way into the cups and placing the set screw in the last possible notch.

On the back side of the wall, plug each letter into the EZLit Power Strip and EZLit Power Supply. Each Power Link has a colored tag that should match the color tag on the Power Strip.

Apply the included dielectric grease to the metal parts of each plug connection, then plug the EZLit Power Strip into a 110-volt outlet.

Leave a loop of wire hanging below the outlet to help prevent water from running down the cord and into the socket.